DOORS 5D 9 without the hinges attached It only the door assem bly is to be serviced it is recommended that the door be removed from the hinges It the hinges 57 J iL LOWER SAW N niust be serviced remove the door and hinges from CHANNEL CAM tg the body as an assembly and remove the hinges I t gqpgvv 5 Md from the door in a bench operation I E N if WTNDOWREAR 1 Apply masking tape as a protective cover ti t T f UP TRAVEL WTNDOW FRONT 5 4 to front edge of door and rear edge ot front fender UP i TRAVEL 4 V STOP BOLT V stop Bott 1 2 Open door and mark location of both upper l x i and lower hinges on door or body hinge pillar 4 INNER PANEL depending on which bolts are to be removed CAM SCPEWS With door properly supported remove either hinge to door or hinge to body attaching bolts Fig 5Dl4 Front Door Hardware Fig 5D13 P To adjust the door up or down in or out or fore 4 Remove door and place on a surface that will or aft proceed as follows Prior to loosening any not damage door finish hinge bolts mark location of hinges on body or door hinge pillar depending on bolts to be loosened 5 To install reverse removal procedure Align hinges within scribe marks and tighten attaching il For up or down and or in or out adjustment bolts Prior to installation of doors that were loosen hinge to body attaching bolts then shift removed with hinges attached apply a coat of door to desired position and tighten bolts heavy bodied sealer to surfaces of hinges that contact body to prevent squeaks and avoid water Check door for proper alignment and if neces leaks at bolt locations sary repeat operation until proper alignment is attained lf needed additional up or down adjust FRONT DOOR ADJUSTMENTS ment is available at hinge to door attaching bolts Door adjustments are provided through the use ZZ For fore or aft adjustment loosen hinge to of floating anchor plates in the door and front door attaching bolts then shift door to desired body hinge pillars When checking the door for position and tighten bolts Check door for proper inisalignment and prior to making any adjustments alignment and if necessary repeat operation until remove striker from body lock pillar to allow proper alignment is attained door to hang free on its hinges 3 Reinstall door lock striker and check lock v extension to lock striker engagement as described ri A 4 under Door Lock Striker Adjustments fi FRONT DOOR WEDGE PLATES UPPER PHNGE fE Door wedge plates are used as a positive hold T 4B 2 UPPERPHTNGE for the door in the closed t Tl l t BOLT5 g r t i posi ion it p a es LELTZOOR ijpi V are secured by screws to the door and body lock M tgt fg I pillar just below the belt line The body wedge plate is made of metal and the door wedge plate t LOWER H N E i of nylon lf necessary shims can be installed L TOV BODY under the door wedge plate to achieve desired A BOLTS li 32 interference between the plates Door wedge plate shims are available as a service part To I x Tm remove either wedge plate merely remove the f j if a Lowen HINGE esi S VS i Qi TO DO R L W s O Fnom DOOR w N 0w UP TRAVEL stops V V Remove d Insvulluticn 1 Raise door window to almost fully closed Fig 5Dl3 Front Door Hinges position