DOORS 5D ll 6 Loosen ventilator attaching screws and ad justing stud nuts at points described below and illustrated in Figure 5D16 a Ventilator division channel lower adjusting stud nut b Door inner panel to ventilator attaching screw REA GLASS rum cninmst c Ventilator adjusting stud nut and ventilator UPPERBOLT 4 attaching bolt located on door hinge pillar 7 Lift window assembly and remove it from DOOR LOCK g M A QB between door panels at belt line SCREWS e 8 To install reverse removal procedure Ad F just window as described below Adjust ventilator J M j as described under Front Door Ventilator I Adjustnients I I U g WK new cuss VENT LATOR FRONT DOOR WINDOW ADJUSTMENTS nur cniwwai IvIsIoN cmwusi Lowzn Auiusnwo LOWERADJU5YING To adjust the front door window up or down STUD NUT 5YUD NUT loosen the front and rear up travel stops Fig M INNER PANEL 5D14 and operate window to desired position cam scasws Then position and tighten adjustable stops on sash channel against welded on stops on front I055 and rear run channels To rotate the glass in the opening lower or raise front edge of glass loosen the inner panel Fig 5D 7 FrOnr Door Hardware g j cam attaching screws Fig 5D14 Raise or lower VENTHATQR L WER adjustable end of cam as required and tighten FRAME BOLT cam screws O k O I if To adjust rear edge of glass in or out at the DOOR INNER PANEL belt line loosen the rear glass run channel upper TO VENTILATOR attaching screw Fig 5Dl I and adjust the run QCREW channel in or out as required 5 To adjust the top edge of glass in or out in relation to side roof rail loosen lower adjusting rg stud nuts of vent division channel and rear glass i C run channel Fig 5D1 7 Adjust studs in or out Gi I as required then tighten stud nuts VENTILATOR LOWER FRAME r Y ADJUSTING STUD 8 NUT Q A Slight fore and aft adjustment is available by Q P ii ffiii adjusting the vent division channel and rear glass Wi run channel fore or aft at the lower adjusting Q in A stud locations Fig 5D1 7I J FRONT DOOR VENTILATOR ASSEMBLY b nemavan md I s II s VENTILATOR DIVISION CHANNEL LOWER my 1 Operate window to full down position Remove ADJUSTING STUD NUT door trim pad and inner panel water deflector I 2 Remove door inner panel to ventilator at Fig 5DI6 Front Deer Ventilator Attachments taching screw at belt Fig 5D16