ably supported as lower sash channel cam could roll off regulator arm s causing damage to door glass 6 To install reverse removal procedure Check operation of ventilator and door window assembly and where required adjust ventilator assembly as described under Adjustments below NOTE On two door styles install ventilator division channel lower adjusting stud to channel prior to installing ventilator Adjustments 1 To adjust ventilator division channel in or out or fore or aft remove door trim assembly and detach inner panel water deflector sufficiently to loosen division channel lower adjusting stud nut fig 10 51 Adjust stud in or out as required or position channel fore or aft as required then tighten stud nut Seal water deflector and install door trim and inside hardware 2 The effort required to open or close the ventilator may be increased or decreased by bending up washer tab and tightening or loosening the adjusting nut fig 10 52 Tightening the adjusting nut will increase effort required to open and close ventilator loosening adjusting nut will decrease opening and closing effort When desired adjustment has been obtained bend down washer tab to lock nut in position b ADJUSTING WASHER TAB NUT Fig 10 52 V ntllator Friction Adjustment NOTE This adjustment should be performed as a bench operation WINDOW ASSEMBLY FRONT DOOR The front door glass is a solid tempered safety plate glass The glass fits into a lower sash channel assembly which incorporates a welded on lower sash channel cam With this type design the door glass lower sash channel and sash channel cam are removed from the door as a unit Removal and Installation 1 Remove door trim assembly and detach inner panel water deflector 2 Remove front door ventilator assembly as previously described under Front Door VentilatorRemoval and Installation CAUTION After ventilator has been removed door glass should be held or otherwise suitably supported as lower sash channel cam could roll off of regulator arms causing damage to door glass 3 To install window assembly reverse removal procedure After installation of window assembly lubricate lower sash channel cam along entire length of cam with lubriplate or its equivalent Adjustments 1 To adjust the lower portion of the ventilator di r WINDOW REGULATOR ATTACHING SCREWS DIVISION CHANNEL LOWER ADJUSTING STUD AND NUT Fig 10 53 Front Door Window Regulator and Lower Ventilator Attachment