1 TO UNLOCK 1 v x y i TO LOCK SCREWS HIDDEN r r 2 Using a suitable tool through access hole remove two nuts securing handle to door outer panel 3 Remove door lock handle and gaskets from outside of body 4 To install reverse removal procedure OUTSIDE HANDLE PUSH BUTTONFRONT DOOR Disassembly and Assembly 1 Remove door outside handle as previously described 2 Depress retainer slightly and turn retainer onequarter turn Remove retainer spring push button and shaft and sealing ring from handle fig 10 60 HANDLE SEALING RING SPRING f d PUSH BUTTON RETAINER f AND SHAFT e ATTACHING NUT AND LOCK WASHER ASSEMBLY Fig 10 60 Front Door Outside Handle Disassembled 3 To install reverse disassembly procedure REAR DOORS REAR DOOR ASSEMBLY AND HINGES The rear door assembly is attached to the body center pillar with two 2 butt type hinges The upper hinge on all styles is secured with three 3 screws to an anchor plate at the door hinge pillar and three 3 bolts to an upper hinge support at the center pillar The lower hinge on all styles incorporates an integral type door check and hold open and is secured with three 3 screws to an anchor plate at both the door hinge pillar and center pillar Removal Either of the following two 2 methods can be used to remove the door from the body The door and hinges can be removed as an assembly from the center pillar The door can be removed from the hinge straps 1 Clean off excess sealer from around each hinge strap and mark hinge location on door hinge pillar or center pillar depending on method of removal being used 2 With door properly supported remove three 3 upper and lower hinge attaching screws at door L fRV IR SNnP MANUAL