dow bend down tab securing center of rear listing wire see View B Remove headlining IMPORTANT Note into which holes the ends of the listing wires are installed in side roof rail dips to insure proper installation See View 6 If necessary listing wires may be removed from pockets Installation 1 If previously removed install listing wires into headlining listing pockets and lift entire assembly into body 2 Install rear listing wire Center and align rear of headlining in relation to back window and side roof rails then bend over tab securing center of rear listing wire see View B Then working forward install ends of listing wires into listing wire holes in side roof rails NOTE Make certain ends of listing wires are SEATS AND SEAT I FRONT SEAT Manually operated front seat adjusters provide fore and aft movement of the seat When the lever at the left seat adjuster is raised the seat adjusters unlock permitting horizontal travel of the seat When the seat is in the desired position the lever is released and the r seat is locked The front seat adjusters and the floor pan at the front support may be reworked to reposition the front seat assembly one 1 inch rearward The seat height may be increased or seat tilt adjusted forward or rearward by shimming r FRONT SEAT ASSEMBLY Removal and Installation 1 Turn back floor carpeting where necessary to expose seat adjuster to seat support attaching bolts 2 Scribe location of rear end of adjuster on front seat rear support and remove adjuster rear attach ing bolts 3 With aid of helper tilt seat assembly forward then slide seat assembly rearward to disengage front legs of adjusters from retainers Remove seat assembly with seat adjusters attached from body 4 To install reverse removal procedure Make certain front legs of adjusters are completely engaged under retainers and adjusters are aligned within scribe marks before installing attaching bolts SEAT ADJUSTERS Removal and Installation 1 Remove front seat assembly with adjusters at installed in correct holes to insure proper contour of headlining See View A 3 At front roof bow check headlining for proper centering and bend tabs over listing wire See View C Install remaining listing wire into holes in side roof rails 4 Center and align headlining in relation to windshield opening sunshade locations and back window location Then apply trim cement to headlin ing tacking surfaces at windshield and back window openings and stretch and stay tack headlining at these locations 5 Apply trim cement to headlining attaching surfaces along side roof rails and carefully cement headlining in place making certain to remove all fullness and draws from material 6 Remove any fullness and draws in headlining material at windshield and back window openings and permanently tack headlining to tacking strips 7 Install all previously removed hardware and trim assemblies and remove protective coverings COMPARTMENT TRIM tached from body and place it upside down on a clean protected bench 2 Remove seat adjuster counter balance spring attached to seat adjuster front support and seat bottom frame as shown in Figure 10 71 3 Operate adjusters so that both front and rear attaching bolts are accessible 4 Squeeze hooked end of seat adjuster locking wire together and slide retaining spring back over hump in locking wire Remove locking wire from adjuster 5 Remove adjuster to seat bottom frame front and rear attaching bolts fig 71 and remove seat adjuster from seat assembly 6 To install reverse removal procedure Check seat assembly for proper operation prior to installing seat assembly NOTE The right and left seat adjuster sliding ORE AR SEAT DIUSTER COUNTERBALANCE SPRING ATTACHING L KIN I BOLTS RETAINERS i WIRE TENSIONAL HOLES Fig 10 71 Seat Adjusters Assembled to Front Seat