IV w 7 O Fig 27 front Mounts 7 Remove front mount bracket and spacer if used 8 Remove front mount retaining nuts then remove front mounts 9 Install front mounts and torque to specifications 10 Install front mount bracket to transmission with the spacer if used on the one 7 16 bolt then torque bolts to specifications 11 Raise engine until weight is on front mount bracket and install nuts and torque to specifications then install cotter key 12 Connect emergency brake return spring 13 On engines equipped with synchromesh transmission connect shift rod coupling to transmission shift rod then install clutch lever ball stud in front mount bracket On engines equipped with Powerglide transmission connect control cable 14 Remove engine lift and Tool J 7894 from underl engine Rear Mount Fig 28 Replacement 1 Place engine lift with Tool J 7894 attached under engine 2 Remove grille and rear center shield then disconnect rear mount from rear mount bracket 3 Lower engine enough to release weight from rear mount 4 Remove four bolts attaching mount to body theri remove mount 5 Install rear mount and torque to specifications 6 Raise engine until weight is on rear mount then install spacer and nuts and torque to specifications 7 Install rear center shield and grille 8 Remove engine lift and Tool J 7894 from unde engine r r m v