I i w I m v o o f o a 6 V 0 Fig 28 Cables Wi ing a bracket to the connector end of the compressor 5 Disconnect the compressor electrical feed and ground wires 6 Remove the through bolt attaching nut and washer B and the pulley end bracket to support assembly bolt nut and washers 7 Slide the compressor toward the rear of the car to 1 disengage it from the through bolt and lift the compressor from the car 8 Remove the bracket from the compressor if necessary 9 Since the service compressor if used will be received less the clutch actuating coil parts and clutch pulley assembly these components if in satisfactory condition should be removed from the malfunction ing compressor and installed on the new compressor NOTE Drain and measure oil in the compressor when it is removed See Checking and Adding Oil Installation 1 Replace the bracket on the compressor if removed I fJr r o 1 y T J I f