| Book |
Page |
Context |
 |
 |
TRANSMISSION Turbo Hydra Mavic 375 400 1 TURBO HYDRA MATIC 11 375 und 400 1 1 1 The 1972 transmission is essentially the same as used in 1971 with the following exceptions ...
inner oil seal ring small diameter requires 1 and assembly is identical to the Turbo Hydra Matic 400 replacement use the aluminum oil seal ring 1 11 with the exception of the number of clutch |
|
 |
CODE The code letter for month and number s I Fig 0 8 Turbo Hydra Matic 375 400 Inc Torcnado fg actual date W Us g Gm EXAMPLE 1 Ml3 Built November 13 M llth ...
1etter I is not used TURBO HYDRA MATIC 375 and 400 The turbo Hydra Matic serial number for all series 1 except Toronado is stamped on a plate located on the right TIRE ROTATION side |
|
 |
bearing rearward out of end frame Clean end frame 400 gipit dor finer lpolishing cloth Thoroughly clean I in clean solvent awaY ust partic es c To rinstall new bearing back up t l1e inside ...
must e r be replaced d The slip rings on the rotor can be cleaned l with 400 grit or fmer polishing cloth When cleaning slip rings the rotor must be rotating to V prevent |
|
 |
Turbo Hydra Matic 375 400 TRANSMISSION 7 3 b Valve body to spacer plate gasket will be used in c T CS switch wiring clip is being omitted and all models the wires routed under |
|
 |
screen coolant level should be checked vinrally at the see through Turbo l Iydra Matic 375 and 400 install new strainer coolant reservoir at each engine oil change while the engine is at normal operating |